Exam Summary
0 of 20 Questions completed
Questions:
Information
You have already completed the exam before. Hence you can not start it again.
Exam is loading…
You must sign in or sign up to start the exam.
You must first complete the following:
Results
Results
0 of 20 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Average score |
|
Your score |
|
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 20
1. Question
Which of these is true about a series circuit?
CorrectIncorrect -
Question 2 of 20
2. Question
What tool can check continuity in wires that carry digital signals?
CorrectIncorrect -
Question 3 of 20
3. Question
While you use a DMM voltmeter function to evaluate voltage drop, the meter leads need to be connected in what way?
CorrectIncorrect -
Question 4 of 20
4. Question
An analog ohmmeter needle won’t move when connected to both sides of the rotor. What does this mean about the rotor winding?
CorrectIncorrect -
Question 5 of 20
5. Question
Technician A states that a short circuit to ground in a circuit decreases resistance. Technician B states that a short circuit increases current flow.
Who is correct?
CorrectIncorrect -
Question 6 of 20
6. Question
Two technicians discuss the state of charge of a battery. Technician A states that a specified gravity of 1.225 at 80F shows the battery has a state of charge at about 75%.
Technician B states that it’s possible to use the hydrometer to check the state of charge if you are troubleshooting a maintenance-free battery.
Who is correct?
CorrectIncorrect -
Question 7 of 20
7. Question
While performing a starter current draw test, you notice the current draw is more than specified. The battery voltages and cranking speed appear to be less than specified.
What is the cause of your problem?
CorrectIncorrect -
Question 8 of 20
8. Question
While discussing an alternator that has zero output, Technician A states that the field circuit might have an open circuit. Technician B states that the fusible link might be open to the alternator from the battery.
Who is correct?
CorrectIncorrect -
Question 9 of 20
9. Question
Technician A states that a loose serpentine alternative drive belt might lead to overcharging. Technician B states that undersized wiring between the battery and alternator might cause undercharging.
Who is correct?
CorrectIncorrect -
Question 10 of 20
10. Question
What would be the least likely reason you experience a dim headlight out of these options?
CorrectIncorrect -
Question 11 of 20
11. Question
The vehicle turn signals begin to flash too slow. Technician A believes that the issue is caused by a faulty flasher. Technician B believes the bulb is an incorrect type.
Who is correct?
CorrectIncorrect -
Question 12 of 20
12. Question
What solder type is needed for instrument panel wiring repair?
CorrectIncorrect -
Question 13 of 20
13. Question
When a faulty fuel gauge indicates a full tank, what’s the most likely reason?
CorrectIncorrect -
Question 14 of 20
14. Question
The rear defogger grid is being tested. Technician A believes that the voltmeter should decrease its reading while probing a grid line as it gets close to the ground bus bar.
Technician B believes that when the voltmeter reads 12 volts at both ends of the grid line, it means there’s an open in the grid line. Who is correct?
CorrectIncorrect -
Question 15 of 20
15. Question
The power seat system is noisy when operated. All of these might be the cause EXCEPT:
CorrectIncorrect -
Question 16 of 20
16. Question
The horn is making a weak sound. Technician A believes the faulty power connection is the reason. Technician B believes the faulty fuse might be the cause.
Who is correct?
CorrectIncorrect -
Question 17 of 20
17. Question
The doors on a vehicle won’t unlock with the remote keyless entry. These could all be the cause EXCEPT:
CorrectIncorrect -
Question 18 of 20
18. Question
The vehicle sunroof works intermittently. Technician A states that it might be a poor wiring connection. Technician B states that the panel might be binding in the rails.
Who is correct?
CorrectIncorrect -
Question 19 of 20
19. Question
How many 2.1-volt cells are in a standard 12-volt car battery?
CorrectIncorrect -
Question 20 of 20
20. Question
According to Kirchhoff’s Voltage Law, the sum of all the voltage drops in a closed loop system are going to be equal to ________.
CorrectIncorrect